![]() ![]() The cost declined over this period from about $1 per bit to about 1 cent per bit. However, reaching this density required extremely careful manufacture, which was almost always carried out by hand in spite of repeated major efforts to automate the process. Using smaller cores and wires, the memory density of core slowly increased, and by the late 1960s a density of about 32 kilobits per cubic foot (about 0.9 kilobits per litre) was typical. Therefore, they are a type of non-volatile memory. When not being read or written, the cores maintain the last value they had, even if the power is turned off. The process of reading the core causes the core to be reset to a zero, thus erasing it. Another wire through each core, the sense wire, is used to detect whether the core changed state. Electric current pulses in some of the wires through a core allow the direction of the magnetization in that core to be set in either direction, thus storing a one or a zero. The value of the bit stored in a core is zero or one according to the direction of that core's magnetization. A core can be magnetized in either the clockwise or counter-clockwise direction. Magnetic hysteresis allows each of the cores to "remember", or store a state.Įach core stores one bit of information. ![]() Two or more wires pass through each core. Such memory is often just called core memory, or, informally, core.Ĭore memory uses toroids (rings) of a hard magnetic material (usually a semi-hard ferrite) as transformer cores, where each wire threaded through the core serves as a transformer winding. Magnetic-core memory was the predominant form of random-access computer memory for 20 years between about 19. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |